Installing The Blade Server Bezel Assembly; Closing The Blade Server Cover - IBM BladeCenter HS20 Installation And User Manual

Installing the blade server bezel assembly

The following illustration shows how to install the blade server bezel assembly.
To install the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. Connect the control-panel cable to the control-panel connector on the system
3. Carefully slide the bezel assembly onto the blade server until it clicks into place.

Closing the blade server cover

Important: The blade server cannot be inserted into the BladeCenter unit until the
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
The following illustration shows how to close the blade server cover.
Cover
Pins
To close the blade server cover, complete the following steps:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. If you removed the blade bezel assembly, replace it now (see "Installing the
3. Lower the cover so that the slots at the rear slide down onto the pins at the rear
Bezel-assembly
release
Control panel
connector
page 21.
board.
Blade-Cover
Release
page 21.
blade server bezel assembly" for instructions).
of the blade server, as shown in the illustration. Before closing the cover, check
Bezel-assembly
release
Control-panel
cable
Blade-Cover
Release
Chapter 3. Installing options
35