Table of Contents
Advertisement
Completing the installation
To complete the installation, perform the following tasks, if you have not already
done so.
1. Install the blade-server bezel assembly on the blade server (see "Installing the
2. Close the blade server cover (see "Closing the blade server cover" on page 42).
3. Reinstall the blade server into the BladeCenter unit .
4. Turn on the blade server (see "Turning on the blade server" on page 9).
5. After you replace the battery or the system-board assembly, reset the system
Note: If you have just connected the power cords of the BladeCenter unit to
Installing the blade server bezel assembly
The following illustration shows how to install the bezel assembly on the blade
server.
Figure 20. Installing the bezel assembly
Complete the following steps to install the blade-server bezel assembly:
40
BladeCenter QS20 Type 0200: Installation and User's Guide
blade server bezel assembly").
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
date and time through the operating system that you installed. For additional
information, see your operating-system documentation.
electrical outlets, you will have to wait until the power-on LED on the blade
server flashes slowly before pressing the power-control button on a blade
server.
Bezel release buttons
Control panel
connector
Bezel release buttons
Serial
connector
Front bezel
Control panel
cable
Serial
cable
Advertisement
Table of Contents
