Installing the bezel assembly
Use this information to install a bezel assembly in the blade server.
Note:
1. The following illustration shows how to install a bezel assembly in a blade
2. The illustrations in this document might differ slightly from your hardware.
To install the bezel assembly, complete the following steps.
1. Orient the bezel with the front of the blade server.
2. If the control-panel cable is not already installed, connect the control-panel
3. Carefully slide the bezel assembly onto the blade server until it clicks into
4. Install the optional expansion unit, if you removed one from the blade server
5. Install the cover onto the blade server (see "Closing the blade server cover" on
6. Install the blade server into the BladeCenter unit (see "Installing the blade
60
BladeCenter HS22V Type 7871 and 1949: Problem Determination and Service Guide
server.
Bezel assembly
release (both sides)
Control-Panel
Connector
cable to the control-panel connector on the blade server.
Note: Some hardware installation and removal procedures that refer to this
installation process do not require the control-panel cable to be installed. For
example, the DIMM connectors can be accessed without removing and
reinstalling the control-panel cable.
place.
(see "Installing an optional expansion unit" on page 58 for instructions).
page 56).
server in a BladeCenter unit" on page 53).
Bezel assembly
Control-Panel
Cable