Installing The Bezel Assembly - IBM PS703 Service Manual

4. Open and remove the blade server cover. See "Removing the blade server cover" on page 233.
Note: If you are servicing the base unit of a PS704 blade server, you must first remove the expansion
unit. For more information, see "Removing the expansion unit for a PS704 blade server" on page 237.
5. Press the cover-assembly release (as shown by 3 in Figure 26 on page 240) on each side of the blade
server and pull the bezel assembly ( 4 ) away from the blade server approximately 1.2 cm (0.5 inch).
6. If you are servicing a base unit and not an expansion unit, disconnect the control-panel ( 1 ) from the
control-panel connector ( 2 ).
7. Pull the bezel assembly away from the blade server.
8. If you are instructed to return the bezel assembly, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Installing the bezel assembly

You can install a bezel on a PS703 blade server, or on either the base unit or the expansion unit of a
PS704 blade server.
Figure 27. Installing the bezel assembly
1. If you are servicing a base unit and not an expansion unit, connect the control-panel cable ( 1 in
Figure 27) to the control-panel connector ( 2 ) on the system board.
2. Carefully slide the bezel assembly ( 4 ) onto the blade server until the two bezel-assembly releases
( 3 ) click into place in the bezel assembly.
3. Install and close the blade server cover. See "Installing and closing the blade server cover" on page
235.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power source. Always
replace the blade server cover before installing the blade server.
Chapter 4. Removing and replacing blade server components
241