Table F-25. Routine 90 - Tape Drive Diagnostic Error Codes - Fujitsu M2488 Product Manual

DIAGNOSTIC TESTS AND ERROR CODES

Table F-25. Routine 90 - Tape Drive Diagnostic Error Codes

ROUTINE TEST
* All Drive Diag tests
0x90
x90 0x01 Drive Diag: LOAD test
0x90 0x02 Drive Diag: AC/PS, MODCH
tests
0x90 0x03 Drive Diag: TPPFM test
0x90 0x04 Drive Diag: LOCAT test
0x90 0x05 Drive Diag: D.S.E test
0x90 0x06 Drive Diag: REWND test
0x90 0x07 Drive Diag: UNLOD test
0x90 0x08 Drive Diag: ACL LDUL test
F-78
ERROR
TITLE
CODE
0xE0
0x01
0x05
0x02
0x02
0x02
0x02
0x02
0x02
0x02
0xE0
0xE1
0xE2
0xE3
0xE4
0xE5
0xE6
0xE7
0xE8
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
DESCRIPTION
A DVL card was not detected. This routine
requires that the DTC card be properly con-
nected to a DVL card.
Error transferring diagnostic parameters
through the Shared RAM interface.
Error receiving diagnostic results through the
Shared RAM interface. (MFG mode only)
Servo error reported during drive diagnostic
cartridge load test.
Servo error reported during drive diagnostic
access/positioning test or mode change test.
Servo error reported during drive diagnostic
tape acceleration/decleration test.
Servo error reported during drive diagnostic
tape locate test.
Servo error reported during drive diagnostic
Data Security Erase test.
Servo error reported during drive diagnostic
rewind test.
Servo error reported during drive diagnostic
cartridge unload test.
A DVL card was not detected. This routine
requires that the DTC card be properly con-
nected to a DVL card.
Autoloader not detected. Must have an auto-
loader attached to run this test.
Servo error reported during tape removal.
Servo error reported during magazine
removal.
Servo error reported during magazine inser-
tion.
Servo error reported while waiting for FACL
door to be closed.
Servo error reported while waiting for START
switch to be pressed to load a tape.
Servo error reported during magazine load.
Servo error detected during magazine opera-
tion.
April 1997