4-3.26.3 Rewind Sense Keys - Fujitsu M2488 Product Manual

TAPE UNIT SCSI COMMANDS
4-3.26.3 REWIND Sense Keys
One of the following sense keys may be returned if a CHECK CONDITION was indicated:
SENSE KEY CONDITION
1h RECOVERED ERROR
2h NOT READY
3h MEDIUM ERROR
4h HARDWARE ERROR
5h ILLEGAL REQUEST
6h UNIT ATTENTION
Bh ABORTED COMMAND
Dh VOLUME OVERFLOW
4-116
1. Recovery was performed when writing buffered data before the
rewind occurred.
2. Retries were needed to complete the rewind operation.
Logical Unit was not ready. The tape cartridge was not loaded or
the logical unit was not made ready.
1. Write of buffered data failed due to a defective tape.
2. An attempt was made to write 36-track data on 18-track format-
ted medium.
1. Write of buffered data failed due to a hardware failure.
2. The rewind operation was not completed because of a hardware
failure.
1. Illegal parameter was found in REWIND command CDB. The
rewind operation was not performed.
2. The Flag bit was set but the Link bit was not set.
Indicates the REWIND command was not performed due to one
of the following:
1. The tape cartridge may have been changed.
2. The target has been reset.
3. The Mode parameters have been changed by another initiator.
4. The version of the microcode has been changed (microcode
downloaded).
5. A cartridge was loaded with a tape length that is too long or too
short.
REWIND command was aborted. The REWIND command can be
reissued.
Write of buffered data prior to the Read Reverse operation failed
because physical End-of-Tape has been reached.
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
DESCRIPTION
April 1997