4-3.6 Inquiry Command 12H; 4-3.6.1 Inquiry Cdb Description; Table 4-15. Inquiry Field Description - Fujitsu M2488 Product Manual

TAPE UNIT SCSI COMMANDS
4-3.6 INQUIRY command 12h
The INQUIRY command provides a means for an initiator to request information regarding parame-
ters of the target and any attached peripheral devices.
4-3.6.1 INQUIRY CDB Description
The INQUIRY CDB is a six-byte command. The bytes are shown below and described in
Table 4-15. Common fields are described in paragraph 4-3.1 on page 4-4.
BYTES 7
0 0
1
2
3
4
5
Note: Changeable fields in the CDB are shaded.
BYTE BIT VALUE
0 0-7
1 0
2 0-7
4 0-7
4-18
6 5 4
0 0 1
LUN
Allocation Length
Reserved

Table 4-15. INQUIRY Field Description

12h Operation code.
1 An Enable Vital Product Data (EVPD) bit of one specifies that the target returns
the optional Vital Product Data (VPD) specified by the Page Code field. See sec-
tion 5-3 for the description of the MTU VPD pages or section 6-4 for the
description of the MC VPD pages supported by the INQUIRY command.The
EVPD bit and its relationship to the Page Code field is shown in Table 4-16.
0 An EVPD bit of 0 indicates transfer of normal INQUIRY data.
The Page Code codes are described in Table 4-17.
The Allocation Length field specifies the maximum number of bytes that the initi-
ator has allocated for returned INQUIRY data. An allocation length of zero indi-
cates no INQUIRY data is to be transferred. This condition is not considered as an
error.
The target terminates the DATA IN phase when allocation length bytes are trans-
ferred or when all available INQUIRY data is transferred to the initiator, which-
ever is less. The user should specify an allocation length of at least 68h (104)
when normal Inquiry data (EVPD=0) is requested.
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
BITS
3 2
0 0
Reserved
Page Code
Reserved
DESCRIPTION
1 0
1 0
EVPD
Flag Link
April 1997