Table B-2. Action Advised Codes - Fujitsu M2488 Product Manual

ASC/ASCQ
Table B-1. ASC and ASCQ Description (by Sense Key) (Continued)
SENSE
ASC/ASCQ
KEY
4 44 00 Hardware error
5 1A 00 Parameter list length error
20 00 Invalid command operation code
21 01 Invalid medium changer element address
24 00 Invalid field in CDB
25 00 Logical unit not supported
26 00 Invalid field in parameter list
30 02 Incompatible format
3B 0D Destination medium changer element full
3B 0E No cartridge or magazine at specified medium changer source element position
3B 8F First destination medium changer element empty
3B 90 Second destination medium changer element full
3B 91 Second destination medium changer element empty
3B 92 Medium changer transport element full
3B 93 Medium changer element is not accessible
3B 94 Drive is full, operation cannot be performed
3D 00 Invalid bits in IDENTIFY message
6 28 00 Not ready to ready transition (Priority 2)
29 00 Power on, reset, or BUS DEVICE RESET occurred (Priority 1)
2A 01 Mode parameters changed (Priority 5)
33 00 Tape length error (Priority 3)
3F 01 Microcode has been changed (Priority 4)
7 27 00 Write protected
8 00 05 Tape void
30 01 Cannot read medium - unknown format
B 43 00 Message reject error
44 00 Internal target failure
45 00 No initiator response to reselection
47 00 SCSI parity error
48 00
Active SCSI command aborted due to an Initiator detected error message being re-
ceived
49 00 Invalid message error
4B 00 SPC transfer offset error or transfer period error
4E 00 Overlapped commands attempted
D 00 02 End-of-Medium detected
ADVISED
ACTION CODE
1 Treat the error as a permanent error.
2 Execute Dynamic Device Reconfiguration (DDR).
3 Continue processing.
B-2
DESCRIPTION

Table B-2. Action Advised Codes

DESCRIPTION
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
ADVISED
ACTION
1
1
1
1
1
1
1
8
1
1
1
1
1
1
1
1
1
7
7
7
7
7
5,4
1
1
1
4
1
1
1
1
4
1
1
April 1997