6-2.4.2 Acl/Facl Tables Of Allowed Moves; Table 6-16. Xcl Allowed Moves - Fujitsu M2488 Product Manual

M2488 PRODUCT GUIDE
The xCL supports Storage element to Storage element moves only when no cartridges are loaded
in the drive.
Send a READ ELEMENT STATUS command before sending a MOVE MEDIUM command to
determine if a move operation is possible.
6-2.4.2 ACL/FACL Tables of Allowed Moves
The data in XCL MODE parameter pages 1Dh (Element Address Assignments) and 1Fh (Device
Capabilities) define the valid MOVE MEDIUM SOURCE and DESTINATION pairs. However,
that information is difficult to read.
The following table shows valid SOURCE/DESTINATION pairs and the result of a MOVE
MEDIUM command using a valid pair.
DESTINATION
SOURCE ADDRESS
0001h 0010h
0011h-0015h 000Dh
0011h-0017h 000Dh
0011h-001Ah 000Dh
0010h 0001h
000Dh 0002h
000Dh 001Nh
0011h-0015h 0011h-0015h
0011h-0017h 0011h-0017h
0011h-001Ah 0011h-001Ah
1
The magazine size can be determined by looking at XCL MODE parameter page 1Dh, bytes 8 and 9.
March 1997

Table 6-16. XCL Allowed Moves

ADDRESS
LOAD MAGAZINE
LOAD CTG (ACL 5 CTG MAGAZINE)
LOAD CTG (FACL 7 CTG MAGAZINE)
LOAD CTG (ACL 10 CTG MAGAZINE)
EJECT MAGAZINE
UNLOAD CTG TO ORIGINAL POSITION
UNLOAD CTG TO EMPTY SLOT N
MOVE FROM FULLSLOT S-10h TO EMPTY SLOT D-10h (5 CTG
MAGAZINE)
MOVE FROM FULLSLOT S-10h TO EMPTY SLOT D-10h (7 CTG
MAGAZINE)
MOVE FROM FULLSLOT S-10h TO EMPTY SLOT D-10h (10 CTG
MAGAZINE)
CG00000-011503 REV. A
MEDIA CHANGER COMMANDS
RESULT
1
1
1
1
1
1
6-17