Table 1-1. Rack-Mount Configurations - Fujitsu M2488 Product Manual

INSTALLATION INSTRUCTIONS
1-3.1 Rack-mount
There are three configurations for the rack-mount M2488 drive. Refer to Table 1-1 for the assembly
instructions to use with your configuration.
CONFIGURATION
M2488 M2488 (one or two per tray)
IPM (one per M2488)
Terminator (may be required)
AC Power Cable (110 or 220 VAC, one per M2488)
Rack-mount tray
Front panel for one M2488 or front panel for two M2488s
M2488 with ACL M2488 (one or two per tray)
IPM (one per M2488)
Terminator (may be required)
AC Power Cable (110 or 220 VAC, one per M2488)
ACL
Rack-mount tray for M2488 with ACL
Front panel for one M2488 with ACL or front panel for
5 or 10-Cartridge Magazine
M2488 with FACL M2488 (one or two per tray)
IPM (one per M2488)
Terminator (may be required)
FACL
AC Power Cable (110 or 220 VAC, one per M2488)
Rack-mount tray for M2488 with FACL
Front panel for one M2488 with FACL or front panel for
7-Cartridge Magazine (one per FACL)
1-2

Table 1-1. Rack-mount Configurations

EQUIPMENT REQUIRED
two M2488s with ACLs
two M2488s with FACLs.
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
ASSEMBLY
TOOLS
PARAGRAPH
Phillips screw- 1-6.1
driver 1-6.2
1-6.3
1-6.5
Phillips screw- 1-6.1
driver 1-6.2
Allen wrench 1-6.3
1-6.5
1-6.6
Phillips screw- 1-6.1
driver 1-6.2
Allen wrench 1-6.3
1-6.5
1-6.7
April 1997