Table of Contents
Advertisement
M2488 PRODUCT GUIDE
1-6.1
General Installation and Assembly Instructions
1-6.1.1
Air Flow and Service Clearances
Allow a gap of 50 mm (2 inches) at the rear of the drive for heat dissipation.
Allow a 620 mm (24 inches) servicing area to the rear, with drive extended, for rack-mounted
drives.
1-6.2
Interface Personality Module Installation
Prior to assembly, ensure all SCSI cables and power cords have
been disconnected. The M2488 should be placed as near as possi-
ble to the main AC outlet.
Installation of the IPM is described below.
IPM
STEP
ACTION
1
Insert the IPM, component side down, into the circuit board at the rear of the M2488. See Figure 1-1.
2
Insert and tighten two screws on the IPM.
April 1997
** NOTE **
Figure 1-1. IPM Installation
CG00000-011503 REV. A
INSTALLATION INSTRUCTIONS
1-9
- Quick Links:
- Configurations
Hide quick links:
Advertisement
Table of Contents
