1-6.5.6 Install The M2488 Or M2488 With Medium Changer On The Mounting Tray; Figure 1-16. M2488 Tray Mounting - Fujitsu M2488 Product Manual

M2488 PRODUCT GUIDE
1-6.5.6 Install the M2488 or M2488 with Medium Changer on the Mounting Tray
Refer to Figure 1-14, Figure 1-16 through Figure 1-19 for this procedure.
NOTE: Before inserting, confirm that the inner cover is on the U-type slit of the mounting tray.
STEP ACTION
1 If a single drive is used, it must be mounted on the right side.
2 Remove the two foot rails from the drive (if installed).
3 Attach drive to the inner cover with four screws (p -CG001901-002).
If attached, the FACL should be flush with the front of the inner cover.
4 Attach the rear of the drive with one screw (r - SW3NA-3x12S-M-NI1A) through the L-type
bracket.
5 Use the correct faceplate (optional) for either a single or dual drives and attach to drives.
M2488
M2488 drive
Inner Cover
C144-E019-04EN
Front Panel

Figure 1-16. M2488 Tray Mounting

INSTALLATION INSTRUCTIONS
Mounting Tray
1-23