Table F-22. Routine 81 - Manufacturing Test Diagnostic Error Codes - Fujitsu M2488 Product Manual

DIAGNOSTIC TESTS AND ERROR CODES

Table F-22. Routine 81 - Manufacturing Test Diagnostic Error Codes

ROUTINE TEST
0x81 * MFG tests
0x81 0x01 Get MFG Parameters
0x81 0x02 Display MFG Parameters
0x81 0x03 Clear Log Counters
0x04 Write BOT - EOT test
0x81
0x81 0x05 Read BOT - EOT test
F-74
ERROR
TITLE
CODE
0xE0
0xE1
-
-
-
0x01
0x02
0x03
0x04
0x05
0x06
0x07
0x08
0x09
0x01
0x02
0x03
0x04
0x05
0x06
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
DESCRIPTION
DVL card not detected. This test cannot be
run without a DVL card connected to the DTC
card
Drive NOT READY error. A working tape
must be loaded to run this test.
No error codes specific to this test
No error codes specific to this test
No error codes specific to this test
Cartridge not installed or drive NOT READY
error. A tape cartridge must be loaded before
this test can be run.
Cartridge WRITE PROTECT error. The car-
tridge must not be write protected for this test.
Buffer space request not granted for data
transfer.
Data transfer timed out.
Fatal error detected during data transfer.
Bad status reported on data transfer complete.
Logical EOT encountered during data trans-
fer.
Buffer flush timeout. Write from data buffer
to tape was not completed in the allocated
time.
Write data in error reported at end of data
transfer.
Cartridge not installed or drive NOT READY
error. A tape cartridge must be loaded before
this test can be run.
Error detected while requesting buffer space
for data transfer.
Data transfer timeout error.
Error reported during data transfer.
Fatal error reported at completion of data
transfer.
Incorrect transfer length, retry required, or
recovered error and incorrect length reported
at end of data transfer.
April 1997