6-2.2.4 Mode Select Mc Sense Keys - Fujitsu M2488 Product Manual

MEDIA CHANGER COMMANDS
For more information on the Medium Changer Mode Parameters see section 6-3 on page 6-32.
6-2.2.4 MODE SELECT MC Sense Keys
One of the following sense keys may be returned if a CHECK CONDITION was indicated:
SENSE KEY CONDITION
1h RECOVERED ERROR
3h MEDIUM ERROR
4h HARDWARE ERROR
5h ILLEGAL REQUEST
6h UNIT ATTENTION
Bh ABORTED COMMAND
Dh VOLUME OVERFLOW
6-10
DESCRIPTION
Recovery was performed when writing buffered data before the buff-
ered mode operation occurred in MODE SELECT command.
1. Write of buffered data failed due to defective tape.
2. An attempt was made to write 36-track data on 18-track formatted
medium.
1. SCSI interface error occurred due to hardware failure (e.g. transfer
of MODE SELECT data failed due to hardware failure).
2. Write of buffered data failed due to a hardware failure.
1. Reserved bit was found set in the CDB of the MODE SELECT
command.
2. Flag bit in the MODE SELECT CDB was set and Link bit was not
set.
3. There is a parameter list error.
Indicates the MODE SELECT command was not performed due to
one of the following:
1. The tape cartridge may have been changed.
2. The target has been reset.
3. The Mode parameters have been changed by another initiator.
4. The version of the microcode has been changed (microcode down-
loaded).
5. A cartridge was loaded with a tape length that is too long or too
short.
MODE SELECT command was aborted.
Write of buffered data prior to the MODE SELECT operation failed
because physical End-of-Tape has been reached.
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
March 1997