Table 4-92. Page 81H Field Description; Table 4-93. Page 90-9Fh - Online Diagnostic Test Page - Fujitsu M2488 Product Manual

TAPE UNIT SCSI COMMANDS
BYTE BIT VALUE
4 0-7
5 0-7
6-11 0-7
12-15 0-7
16-19 0-7
20-23 0-7
24 0-7
25 0-7
26-41 0-7
Description of the Page Code 90-9Fh

Table 4-93. Page 90-9Fh - Online Diagnostic Test Page

BYTES 7
0
1
2-3
4-5
6-7
8-9
10-11
12-13
14-15
4-94

Table 4-92. Page 81h Field Description

The Routine in Error field contains the Routine ID of the failing routine. If this
field contains 00h, no errors were detected during the last execution of a SEND
DIAGNOSTIC command.
The Execute Count field contains the number of passes attempted before an error
was detected. If an error is detected on the first pass, this field contains a 1. This
field is reset each time a new (different) routine is started. For example: if the
SEND DIAGNOSTIC command Parameter list contained a pass count of 4 for
Routine 50, and a pass count of 7 for Routine 51, and an error was detected on
the third attempt to execute Routine 51, this field would contain a 3.
This field contains the Fault Symptom Codes that indicate the cause of the error.
This field contains the data that was expected by the diagnostic test reporting an
error.
This field contains the data that was received by the diagnostic test reporting the
error.
This field contains the hardware address where the expected and received data
comparison was made by the diagnostic test reporting the error.
This field contains the Permanent Error Sense ERPA code relating to the
reported error.
This field contains the Permanent Error Sense Format code.
This field contains the Permanent Error Sense Data bytes.
BITS
6 5 4
Page Code (90-9Fh)
Reserved
Page Length (0020h)
MTU DIAG error code
MTU DIAG result data 1
MTU DIAG result data 2
MTU DIAG result data 3
MTU DIAG result data 4
MTU DIAG result data 5
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
DESCRIPTION
3 2 1 0
April 1997