Table F-5. Routine 3 - Cp Bus Parity Diagnostic Error Codes - Fujitsu M2488 Product Manual

M2488 PRODUCT GUIDE

Table F-5. Routine 3 - CP Bus Parity Diagnostic Error Codes

ROUTINE TEST
0x01 CP Bus parity - Control Store
0x03
April 1997
ERROR
TITLE
CODE
0x01
0x02
0x03
0x04
0x05
0x06
0x07
0x10
0x11
0x12
0x13
0x20
0x21
0x22
0x23
0x30
0x31
CG00000-011503 REV. A
DIAGNOSTIC TESTS AND ERROR CODES
DESCRIPTION
An unexpected Check 1 condition was prema-
turely detected at the beginning of this test
CP Bus parity error was not set as expected
after attempting a read a Control Store loca-
tion previously written with bad parity
An unexpected Check 1 condition was pend-
ing after it should have been cleared
A CP bus parity error was not detected as
expected after a write/read operation on a
word of control store with forced bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
A CP bus parity error was not detected as
expected after reading a word previously writ-
ten with bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
A CP bus parity error was not detected after
writing byte 0 of a word with bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
A CP bus parity error was not detected after
reading byte 0 of a word which was previ-
ously written with bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
A CP bus parity error was not detected after
writing byte 1 of a word with bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
A CP bus parity error was not detected after
reading byte 1 of a word which was previ-
ously written with bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
A CP bus parity error was not detected after
writing byte2 of a word with bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
F-9