6-2.1.2 Exchange Medium Examples; Table 6-2. M2488A11 (Acl) Exchange Medium Examples; Table 6-3. M2488A12 (Facl) Exchange Medium Examples - Fujitsu M2488 Product Manual

M2488 PRODUCT GUIDE
EXCHANGE MEDIUM commands when the source element type is the same as second destina-
tion element type.
Send a READ ELEMENT STATUS command before sending an EXCHANGE MEDIUM com-
mand to determine if an exchange is possible.
6-2.1.2 Exchange Medium Examples
The data in XCL MODE parameter pages 1Dh (Element Address Assignments) and 1Fh (Device
Capabilities) define the valid MOVE MEDIUM SOURCE and DESTINATION pairs. However,
that information is difficult to read.
The following tables show data inputs to and the result of an EXCHANGE MEDIUM command
using the data.

Table 6-2. M2488A11 (ACL) Exchange Medium Examples

FIRST
SOURCE
DESTINATION
11h 12h
11h 12h
X Y
X Y
1
The magazine size can be determined by looking at XCL MODE parameter page 00h.

Table 6-3. M2488A12 (FACL) Exchange Medium Examples

FIRST
SOURCE
DESTINATION
17h 16h
16h 15h
X Y
X Y
March 1997
SECOND
DESTINATION
This is not valid for an ACL. It will be rejected with CHECK
11h CONDITION status and the sense key set to ILLEGAL
REQUEST.
Move cartridge in slot 02h to empty slot 03h then move cartridge
13h
from 01h to 02h
This is not valid for an ACL. It will be rejected with CHECK
X CONDITION status and the sense key set to ILLEGAL
REQUEST.
Move cartridge in slot Y-10h to empty slot Z-10h then move car-
Z
tridge in slot X-10h to slot Y-10h.
SECOND
DESTINATION
Exchange cartridges in slots 06h and 07h. This will work
17h
with a full magazine.
Move cartridge in slot 05h to empty slot 04h then move car-
14h
tridge from slot 06h to 05h
Where: X={11h,12h,...,17h} and Y<>X. Exchange car-
X tridges in slots X-10h and Y-10h. This will work with a full
magazine.
Move cartridge in slot Y-10h to empty slot Z-10h then move
Z
cartridge in slot X-10h to slot Y-10h.
CG00000-011503 REV. A
MEDIA CHANGER COMMANDS
RESULT
RESULT
6-3