Fujitsu M2488 Product Manual page 410

DIAGNOSTIC TESTS AND ERROR CODES
Table F-5. Routine 3 - CP Bus Parity Diagnostic Error Codes (Continued)
ROUTINE TEST
0x01 CP Bus parity - Control Store
0x03
0x03 0x02 CP Bus parity - SDDP
F-10
ERROR
TITLE
CODE
0x32
0x33
0x40
0x41
0x42
0x43
0x50
0x01
0x02
0x03
0x04
0x05
0x06
0x07
0x08
0x09
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
DESCRIPTION
A CP bus parity error was not detected after
reading byte2 of a word which was previously
written with bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
A CP bus parity error was not detected after
writing byte 3 of a word with bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
A CP bus parity error was not detected after
reading byte 3 of a word which was previ-
ously written with bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
An unexpected Check 1 condition was
detected after attempting to write a word with
good parity to control store
An unexpected Check 1 condition was prema-
turely detected at the beginning of this test
An unexpected Check 1 condition was
detected after reading the HDXC register in
the SDDP
A CP bus parity error was not detected as
expected after a SDDP register write opera-
tion with forced bad parity
An unexpected Check 1 condition was pend-
ing after an attempt to clear it was made
A data miscompare was detected reading an
SDDP register previously written with bad
parity
An unexpected Check 1 condition was
detected after reading an SDDP register
An unexpected Check 1 condition was
detected after attempting to restore the con-
tents of the HDXC register
A data miscompare was detected when verify-
ing the contents of the HDXC register previ-
ously restored
An unexpected Check 1 condition was pend-
ing after read verification of the HDXC regis-
ter was completed
April 1997