Fujitsu M2488 Product Manual page 440

DIAGNOSTIC TESTS AND ERROR CODES
Table F-14. Routine 12 - EDRC Address Bus Diagnostic Error Codes (Continued)
ROUTINE TEST
0x02 SDDP-R20 testing 64k sgc-i-
0x12
mem, mode 14h
0x12 0x03 SDDP-R20 testing 16k sgd-i-
mem, mode 04h
0x12 0x04 SDDP-R20 testing sgd-de con-
trols, mode 00h
F-40
ERROR
TITLE
CODE
0x07
0x08
0x09
0x0A
0x0B
0x01
0x02
0x03
0x04
0x05
0x07
0x01
0x02
0x03
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
DESCRIPTION
All the data expected to be transferred out of
the SPC data fifo was not transferred to the
SDDP.
host data transfer end of transfer was received
when not expected, check to see if flush is tied
high to some other signal.
host data transfer end of transfer was not
received when expected, check to see if flush
is tied low to some other signal.
Host data transfer error detected on the retry
mode of this test.
A byte for byte miscompare was detected on
the data bytes stored in the data_buffer.
After start of read operation, SPC-status did
not have SPC-busy and data_ready, possible
sddp did not send data to spc.
Once read operation had started, slow micro-
code was able to pull data out of spc_data fifo
faster then sddp could put into data fifo. Pos-
sible that the data pipe is broken.
At end of read operation, the SPC-status
should be not busy, not data_ready, and
data_fifo empty.
All the data expected to be transferred from
the SPC data_fifo to the SPC receive_buffer
was not transferred.
A non SUCCESS status was returned from
the function call rm_host_rd_complt. A error
was detected in the SDDP_HI-hdxs register.
A byte for byte miscompare was detected on
the data bytes stored in the SPC receive
buffer.
After start of read operation, SPC-status did
not have SPC-busy and data_ready, possible
sddp did not send data to spc.
Once read operation had started, slow micro-
code was able to pull data out of spc_data fifo
faster then sddp could put into data fifo. Pos-
sible that the data pipe is broken.
At end of read operation, the SPC-status
should be not busy, not data_ready, and
data_fifo empty.
April 1997