Fujitsu M2488 Product Manual page 389

M2488 PRODUCT GUIDE
Table E-1. CHK xx Error Code Descriptions (Continued)
CHK XX
CODE
4C CARTRIDGE UNLOAD TIME OUT
4D TAPE UNLOAD TIME OUT
THREADING TIME WAS TOO FAST
4E
4F UNTHREADING TIME WAS TOO FAST
50 THREADER ARM IS NOT HOME DURING CART. LOADING
51 FILE PROTECT SENSOR IS ALWAYS OFF (WRITE ENABLE)
52 FILE REEL DIRECTION ERROR DUE TO LOOSE TAPE WRAP
53 FILE REEL TURNS TOO FAST DUE TO LOOSE TAPE WRAP
54 TAPE PATH SENSOR <CT> IS NOT OFF DURING THREADING
55 FILE REEL DIRECTION ERROR DURING THREADING
56 FILE REEL TURNS TOO SLOW DURING UNTHREADING
57 FILE REEL DIRECTION ERROR DURING UNTHREADING
58 CARTRIDGE \ IN\ OR \ MOUNT\ SENSOR FAILURE
59 MACHINE REEL TACHOMETER FAILURE IN UNLOAD
5A ABNORMAL REEL CLUTCHING DURING LOAD OR TOO LOOSE WRAP
5B NO CARTRIDGE OR FILE PROTECT SENSOR ERROR (LD.)
5C CARTRIDGE IS NOT LOADING POSITION AT START OF LOAD
5D FILE REEL TURNS TOO FAST AFTER UNTHREADING
5E MACHINE REEL TURNS TOO SLOW DURING CLEANING
5F FILE REEL TURNS TOO FAST DURING CLEANING
60 MACHINE REEL TACHOMETER PHASE ERROR DURING THREAD/UNTHREAD
62 MACHINE REEL STOP LOCK ERROR DURING THREAD/UNTHREAD
63 FILE REEL DIRECTION ERROR WHEN CLEANING
64 MACHINE REEL DOES NOT TURN DURING POWER UP
65 MACHINE REEL TACHOMETER OR DIRECTION ERR
66 FILE REEL DOES NOT TURN IN POWER UP
67 FILE REEL TACHOMETER OR DIRECTION ERR
68 FRONT/REAR CARRIER SENSORS BOTH ON
6A BACKWARD AT BOT DETECTED BY SERVO
6B FORWARD AT EOT DETECTED BY SERVO
6C STOP LOCK ERROR CAUSED BY LOOSE WRAP
April 1997
DESCRIPTION
CG00000-011503 REV. A
CHK XX ERROR CODES
E-3