Fujitsu M2488 Product Manual page 437

M2488 PRODUCT GUIDE
Table F-13. Routine 11 - EDRC Data Buffers Diagnostic Error Codes (Continued)
ROUTINE TEST
0x09 Read EDRC32 bytes walking 0,
0x11
mode 00h
0x11 0x0A Write EDRC32 bytes walking 1,
mode 10h
April 1997
ERROR
TITLE
CODE
0x02
0x03
0x04
0x05
0x07
0x01
0x02
0x03
0x04
0x05
0x06
0x07
CG00000-011503 REV. A
DIAGNOSTIC TESTS AND ERROR CODES
DESCRIPTION
when transferring data from the SPC data_fifo
to the SPC receive_buffer, the SPC-ssig regis-
ter did not have the expected bits set:
SCSI_REQ, SCSI_BSY, xfer_phase.
when transferring data from the SPC data_fifo
to the SPC receive_buffer, the SPC-ssig regis-
ter did not have the expected bits set:
~SCSI_REQ, SCSI_ACK, SCSI_BSY,
xfer_phase.
All the data expected to be transferred from
the SPC data_fifo to the SPC receive_buffer
was not transferred.
A non SUCCESS status was returned from
the function call rm_host_rd_complt. A error
was detected in the SDDP_HI-hdxs register.
A byte for byte miscompare was detected on
the data bytes stored in the SPC receive
buffer.
after a write diag operation was initialized in
the spc chip, the SPC-status register did not
have one of the following:
SPC_data_trans_rdy, SPC_busy, or
SPC_data_reg_empty.
when transferring data from the SPC send
buffer to the SPC data fifo, the SPC-ssig regis-
ter did not have the expected bits set:
SCSI_REQ, SCSI_BSY, xfer_phase.
when transferring data from the SPC send
buffer to the SPC data fifo, the SPC-ssig regis-
ter did not have the expected bits set:
~SCSI_REQ, SCSI_ACK, SCSI_BSY,
xfer_phase.
A non SUCCESS status was returned from
the function call rm_request_wrtbuffer.
All the data expected to be transferred out of
the SPC data fifo was not transferred to the
SDDP.
A non SUCCESS status was returned from
the function call rm_host_wrt_cmplt. A error
was detected in the SDDP_HI-hdxs register.
A byte for byte miscompare was detected on
the data bytes stored in the data_buffer.
F-37