6-2.4 Move Medium Mc Command A5H; 6-2.4.1 Move Medium Cdb Description; Table 6-15. Move Medium Field Description - Fujitsu M2488 Product Manual

MEDIA CHANGER COMMANDS
6-2.4 MOVE MEDIUM MC command A5h
The MOVE MEDIUM medium-changer command requests that the target move a unit of media from
a source element to a destination element.
6-2.4.1 MOVE MEDIUM CDB Description
MOVE MEDIUM is a twelve-byte command. The bytes are shown below and described in the fol-
lowing paragraphs. Common fields are described in paragraph 4-3.1 on page 4-4.
BYTES 7
0 1
1
2 MSB
3
4 MSB
5
6 MSB
7
8
9
10
11
Note: Changeable fields in the CDB are shaded.
BYTE BIT VALUE
0 0-7 A5h
2-3 0000h or
000Eh
4-5
6-7
The device capabilities page (XCL MODE parameters page 1Fh) provides a matrix with the sup-
ported source element or destination element combinations for the MOVE MEDIUM command.
If the move addresses are valid and one of the addresses is the Data Transfer Element, a synchro-
nize operation is performed before the media movement begins.
6-16
6 5 4
0 1 0
LUN
Transport Element Address
Source Address
Destination Address
Reserved
Reserved

Table 6-15. MOVE MEDIUM Field Description

Operation code.
This command will only accept Transport element addresses of 0000h (default) or
000Eh (Transport Element address).
The source address specifies the location that the medium is taken from.
The destination address specifies the location that the medium is moved to.
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
BITS
3 2
0 1
Reserved
Reserved
DESCRIPTION
1 0
0 1
LSB
LSB
LSB
0
Flag Link
March 1997