Fujitsu M2488 Product Manual page 445

M2488 PRODUCT GUIDE
Table F-15. Routine 13 - EDRC Error Detection Diagnostic Error Codes (Continued)
ROUTINE TEST
0x01 Write Hi_data parity error check
0x13
0x13 0x02 Read Hi_data parity error check
April 1997
ERROR
TITLE
CODE
0xA3
0xA4
0x01
0x02
0x03
0x04
0x05
0x06
0xB0
0xB1
0xB2
0xB3
0xB4
0x01
0x02
0x03
0x04
0x05
0x06
0x07
0x08
CG00000-011503 REV. A
DIAGNOSTIC TESTS AND ERROR CODES
DESCRIPTION
SPC interrupt/step code did not report Diag-
nostic Self-Test passed
The SPC interrupt request could not be
cleared
Bad SPC write initialization status.
Incorrect SPC SCSI control signal status wait-
ing for REQ signal assertion.
Incorrect SPC SCSI control signal status wait-
ing for REQ signal deassertion.
Error reported by record manager attempting
to request buffer for write clear SG-bypass.
Data transfer length error reported by SPC.
Expected data parity error on high byte of the
DMA bus from SPC failed to be reported by
SDDP.
SPC did not generate an interrupt request
SPC interrupt was not detected at the Interrupt
Request Controller
The SPC interrupt was cleared while clearing
the Interrupt Request Controller.
SPC interrupt/step code did not report Diag-
nostic Self-Test passed
The SPC interrupt request could not be
cleared
Failed to receive data end-of-transfer signal in
SDDP hdxs register.
Incorrect SPC SCSI control signal status wait-
ing for REQ signal assertion.
Incorrect SPC SCSI control signal status wait-
ing for REQ signal deassertion.
Data transfer length error reported by SPC
SPC did not generate an interrupt request
SPC interrupt was not detected at the Interrupt
Request Controller
The SPC interrupt was cleared while clearing
the Interrupt Request Controller.
SPC interrupt/step code did not report Diag-
nostic Self-Test passed
F-45