4-3.13.5 Mode Sense Sense Keys - Fujitsu M2488 Product Manual

TAPE UNIT SCSI COMMANDS
4-3.13.5 MODE SENSE Sense Keys
One of the following sense keys may be returned if a CHECK CONDITION was indicated:
SENSE KEY CONDITION
1h RECOVERED ERROR
3h MEDIUM ERROR
4h HARDWARE ERROR
5h ILLEGAL REQUEST
6h UNIT ATTENTION
Bh ABORTED COMMAND
Dh VOLUME OVERFLOW
4-62
Recovery was performed when writing buffered data, before the
buffered mode operation occurred in MODE SENSE command.
1. Write of buffered data failed due to a defective tape.
2. An attempt was made to write 36-track data on 18-track format-
ted medium.
1. SCSI interface error occurred due to a hardware failure (e.g.
transfer of MODE SENSE data failed due to a hardware fail-
ure).
2. Write of buffered data failed due to a hardware failure.
1. Reserved bit was found set in the CDB of the MODE SENSE
command.
2. Flag bit in the MODE SENSE CDB was set and the Link bit
was not set.
Indicates the MODE SENSE command was not performed due to
one of the following:
1. The tape cartridge may have been changed.
2. The target has been reset.
3. The Mode parameters have been changed by another initiator.
4. The version of the microcode has been changed (microcode
downloaded).
5. A cartridge was loaded with a tape length that is too long or too
short.
MODE SENSE command was aborted.
Write of buffered data prior to the MODE SENSE operation failed
because physical End-of-Tape has been reached.
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
DESCRIPTION
April 1997