4-3.10.4 Log Sense Sense Keys - Fujitsu M2488 Product Manual

TAPE UNIT SCSI COMMANDS
4-3.10.4 LOG SENSE Sense Keys
One of the following sense keys may be returned if a CHECK CONDITION was indicated:
SENSE KEY CONDITION
1h RECOVERED ERROR
3h MEDIUM ERROR
4h HARDWARE ERROR
5h ILLEGAL REQUEST
6h UNIT ATTENTION
4-48
DESCRIPTION
Recovery was performed when writing buffered data to tape.
1. Writing buffered data to tape failed due to defective tape.
2. An attempt was made to write 36-track data on 18-track format-
ted medium.
Write buffered data to tape failed due to a hardware error.
1. Reserved bit was found set in the CDB of the LOG SENSE
command.
2. The Flag bit was set but the Link bit was not set.
3. The Page Code field contained values other than 00h, 02h, 03h,
0Ch, 31h, and 3Eh.
4. The PPC field contained a value other than 0b.
5. The PC field contained a value other than 01b.
Indicates the LOG SENSE command was not performed due to
one of the following:
1. The tape cartridge may have been changed.
2. The target has been reset.
3. The Mode parameters have been changed by another initiator.
4. The version of the microcode has been changed (microcode
downloaded).
5. A cartridge was loaded with a tape length that is too long or too
short.
M2488 PRODUCT GUIDE
C144-E019-04EN