Fujitsu M2488 Product Manual page 391

M2488 PRODUCT GUIDE
Table E-1. CHK xx Error Code Descriptions (Continued)
CHK XX
CODE
9B DOOR SOLENOID LOCK SENSOR ALWAYS ON
9C DOOR SOLENOID LOCK SENSOR OFF
9D SERVO PROGRAM ERROR
9E FACL OVER CURRENT DETECTED
A1 MISSING GAP IN INTERRUPT ON MOTION COMMAND
SERVO COMMAND FAILED TO COMPLETE IN ALLOTTED TIME
A2
A3 MOTION COMMAND TO NOT READY DEVICE
A4 WRITE OR D.S.E. COMMAND TO FILE PROTECTED DEVICE
A5 NO RESPONSE FROM SERVO MPU SENDING COMMAND
A9 WRITE FPC CABLE CHECK WRAP 1
AA WRITE FPC CABLE CHECK WRAP 2
AE PROGRAM DOWN LOAD FAILURE
AF CANNOT EXECUTE PROGRAM DOWN LOAD
B0 TRANSFER DATA COUNT ERROR
B1 WRAP DIRECTION ERROR
B2 INVALID SECTOR
B3 UNEXPECTED COMMAND END INTERRUPT
B4 AUTOLOADER COMMAND RECEIVED TO NONEXISTENT DEVICE
B6 UNACCEPTABLE AUTOLOADER PARAMETER
B9 RESET KEY PRESSED BY OPERATOR
C0 LOAD MAGAZINE COMMAND CAN NOT EXECUTE
C1 MOVE MAGAZINE COMMAND PARAMETER ERROR
C2 MOVE MAGAZINE COMMAND CAN NOT EXECUTE
C3 NO MAGAZINE AT CTG UNLOAD
C4 ACL OVER CURRENT
C5 PINION PHASE ADJUST TIMEOUT
C6 BOTTOM STOPPER-ARM MOVING RETRIES EXHAUSTED
C7 BOTTOM STOPPER SENSOR <UP> & <DW> BOTH ON
C8 DOWNWARD MOVE MAGAZINE TIMEOUT
C9 UPWARD MOVE MAGAZINE TIMEOUT
CA MAGAZINE POSITION MISCALCULATION
April 1997
DESCRIPTION
CG00000-011503 REV. A
CHK XX ERROR CODES
E-5