Table F-18. Routine 51 - Incrementing Block Length Test Error Codes - Fujitsu M2488 Product Manual

M2488 PRODUCT GUIDE

Table F-18. Routine 51 - Incrementing Block Length Test Error Codes

ROUTINE TEST
* Incrementing block length tests
0x51
0x51 0x01 Write incrementing blocks test
0x51 0x02 Rewind test
0x51 0x03 Read incrementing blocks test
April 1997
ERROR
TITLE
CODE
0xE0
0xE1
0xE2
0xE3
0x01
0x02
0x03
0x04
0x05
0x06
0x07
0x08
0x09
0x01
0x02
0x03
0x04
0x01
0x02
CG00000-011503 REV. A
DIAGNOSTIC TESTS AND ERROR CODES
DESCRIPTION
DVL card connection was not detected by the
DTC.
A working tape was not loaded, or the tape
drive was not READY when the test started.
The tape drive is not READY.
The tape (or magazine) is FILE PRO-
TECTED.
Cartridge not installed or drive NOT READY
error. A tape cartridge must be loaded before
this test can be run.
Cartridge WRITE PROTECT error. The car-
tridge must not be write protected for this test.
Buffer space request not granted for data
transfer.
Data transfer timed out.
Fatal error detected during data transfer.
Bad status reported on data transfer complete.
Logical EOT encountered during data trans-
fer.
Buffer flush timeout. Write from data buffer
to tape was not completed in the allocated
time.
Write data in error reported at end of data
transfer.
Cartridge not installed or drive NOT READY
error. A tape cartridge must be loaded before
this test can be run.
Timeout waiting for Servo Command Com-
plete during rewind operation.
Timeout waiting for Formatter Action Com-
plete during rewind operation.
Record Manager or Servo error reported dur-
ing rewind operation.
Cartridge not installed or drive NOT READY
error. A tape cartridge must be loaded before
this test can be run.
Error detected while requesting buffer space
for data transfer.
F-67