4-3.20.5 Receive Diagnostic Results Sense Keys - Fujitsu M2488 Product Manual

M2488 PRODUCT GUIDE
4-3.20.5 RECEIVE DIAGNOSTIC RESULTS Sense Keys
One of the following sense keys may be returned if a CHECK CONDITION was indicated:
SENSE KEY CONDITION
1h RECOVERED ERROR
3h MEDIUM ERROR
4h HARDWARE ERROR
5h ILLEGAL REQUEST
UNIT ATTENTION
6h
Bh ABORTED COMMAND
Dh VOLUME OVERFLOW
April 1997
Recovery was performed when writing buffered data, before the
buffered mode operation occurred in RECEIVE DIAGNOSTIC
RESULTS command.
1. Write of buffered data failed due to a defective tape.
2. An attempt was made to write 36-track data on 18-track format-
ted medium.
1. SCSI interface error occurred due to a hardware failure (e.g.
transfer of RECEIVE DIAGNOSTIC RESULTS data failed
due to a hardware failure).
2. Write of buffered data failed due to a hardware failure.
1. Reserved bit was found set in the CDB of the RECEIVE DIAG-
NOSTIC RESULTS command.
2. Flag bit in the RECEIVE DIAGNOSTIC RESULTS CDB was
set and the Link bit was not set.
Indicates the RECEIVE DIAGNOSTIC RESULTS command was
not performed due to one of the following:
1. The tape cartridge may have been changed.
2. The target has been reset.
3. The Mode parameters have been changed by another initiator.
4. The version of the microcode has been changed (microcode
downloaded).
5. A cartridge was loaded with a tape length that is too long or too
short.
RECEIVE DIAGNOSTIC RESULTS command was aborted.
Write of buffered data prior to the RECEIVE DIAGNOSTIC
RESULTS operation failed because physical End-of-Tape has
been reached.
CG00000-011503 REV. A
TAPE UNIT SCSI COMMANDS
DESCRIPTION
4-97