4-3.27 Send Diagnostic Command 1Dh; 4-3.27.1 Send Diagnostic Cdb Description; Table 4-107. Send Diagnostic Field Description - Fujitsu M2488 Product Manual

Hide thumbs Also See for M2488:
Table of Contents

Advertisement

M2488 PRODUCT GUIDE
4-3.27
SEND DIAGNOSTIC command 1Dh
The SEND DIAGNOSTIC command requests the target to perform diagnostic tests on itself, or on
the attached peripheral devices. After the receipt of a valid SEND DIAGNOSTIC command, the unit
performs synchronization prior to execution of the SEND DIAGNOSTIC operation. Disconnection
occurs, if allowed, during the execution of the function. When the Selftest bit is zero, this command
is usually followed by a RECEIVE DIAGNOSTIC RESULTS command.
4-3.27.1
SEND DIAGNOSTIC CDB Description
SEND DIAGNOSTIC is a six-byte command. The bytes are shown below and described in
Table 4-107. Common fields are described in paragraph 4-3.1 on page 4-4.
BYTES
7
0
0
1
2
3
MSB
4
5
Note: Changeable fields in the CDB are shaded.
The following Field Description table specifies the use of each field of the SEND DIAGNOSTIC
CDB. Refer to Table 4-108 in conjunction with the following table for a more concise overview of
how each field is used.

Table 4-107. SEND DIAGNOSTIC Field Description

BYTE
BIT
VALUE
0
0-7
1Dh
1
0
1
1
1
2
April 1997
6
5
4
0
0
1
LUN
PF
Parameter List Length
Reserved
Operation code.
1
A UnitOfL (Unit Offline) bit of 1 enables write operations on user medium or opera-
tions that affect user visible medium positioning.
1
A DevOfL (Device Offline) bit of 1 enables diagnostic operations that may adversely
affect operations to other logical units on the same target.
1
A Selftest bit of 1 directs the target to complete its default selftest.
0
A Selftest bit of 0 directs the target to perform tests defined by the bytes in the
parameter list. Successful completion of the function and preparation of a response is
indicated by presentation of GOOD status. The response is then recovered by execu-
tion of the RECEIVE DIAGNOSTIC RESULTS command.
CG00000-011503 REV. A
TAPE UNIT SCSI COMMANDS
BITS
3
2
1
1
Reserved
Selftest
Reserved
DESCRIPTION
1
0
0
1
DevOfL
UnitOfL
LSB
Flag
Link
4-117

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents