M2488 PRODUCT GUIDE
8-11.3
IPM Remove and Replace Procedures
Refer to Figure 8-5 for location of the PCA-IPM.
8-11.3.1
IPM Removal
STEP
ACTION
1
Disconnect cables and, if applicable, terminator from the two connectors on the IPM.
2
Remove the two screws from the IPM.
3
Pull out the IPM.
8-11.3.2
IPM Replacement
STEP
ACTION
1
Insert the IPM into the rear of the drive.
2
Tighten two screws on the IPM.
3
Connect cables and, if applicable, terminator to the connectors.
April 1997
Figure 8-5. IPM
CG00000-011503 REV. A
MAINTENANCE AND SERVICING
8-45