Table F-23. Routine 82 - Magnetic Tape Unit Diagnostic Error Codes; Table F-24. Routine 83 - Operator Control Panel Diagnostic Error Codes - Fujitsu M2488 Product Manual

DIAGNOSTIC TESTS AND ERROR CODES

Table F-23. Routine 82 - Magnetic Tape Unit Diagnostic Error Codes

ROUTINE TEST
* MTU diagnostics routine
0x82
0x82 0x01 MTU diagnostic load execute
table
0x82 0x02 MTU diagnostic send execute
table
0x82 0x03 MTU diagnostic run
0x82 0x04 MTU diagnostic retrieve results
table

Table F-24. Routine 83 - Operator Control Panel Diagnostic Error Codes

ROUTINE TEST
0x83 * All Operator Control Panel tests
0x83 0x01 Operator Control Panel keys test
F-76
ERROR
TITLE
CODE
0xE0
-
0x01
0x01
0x02
0x03
0x04
0x05
0x01
ERROR
TITLE
CODE
0xE0
0x01
0x02
0x03
0x04
0x05
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
DESCRIPTION
A DVL card was not detected. This routine
requires that the DTC card be properly con-
nected to a DVL card.
(No error codes specific to this test)
The MTU diagnostic parameters were not
successfully downloaded through the Servo
Shared RAM Interface.
Servo Interface indicated that a servo com-
mand was not accepted
Servo Interface indicated that an error
occurred while processing the current Servo
Command. Sense information was built.
The current servo command failed to com-
plete in the allocated time.
An error occurred during execution of the cur-
rent servo command. Sense information was
built.
No valid test groups were found.
An error occurred attempting to retrieve the
MTU diagnostic results through the Servo
Shared RAM Interface.
DESCRIPTION
Operator Control Panel interface to the DTC
card not detected.
RESET switch press not detected in allotted
time.
RESET switch release not detected in allotted
time.
UNLOAD switch press not detected in allot-
ted time.
UNLOAD switch release not detected in allot-
ted time.
START switch press not detected in allotted
time.
April 1997