Table 4.115 Error Recovery Control Flags During The Self-Diagnosis Test - Fujitsu MAX3036RC SERIES Specifications

Command Specifications
•
The AWRE, ARRE and TB flags are not applied.
•
The PER and DTE flags are as shown in Table 4.115.

Table 4.115 Error recovery control flags during the self-diagnosis test

PER DTE
0 0 The diagnostic test continues when error recovery is successful. The contents
of recovered errors are not reported. When an error which cannot be recovered
from is detected, the diagnostic test terminates at that point with an error.
0 1
1 0 The diagnostic test continues when error recovery is successful. When an error
which cannot be recovered from is detected, the diagnostic test terminates at
that point with an error. Even when all the detected errors have been recovered,
a CHECK CONDITION status (RECOVERED ERROR [=1]) is reported after
the series of diagnostic tests is completed and the sense data show the contents
of the last error to be successfully recovered from.
1 1 When error recovery is successful, or even when error recovery is impossible,
the diagnostic test is terminated with an error at the point when the permitted
error recovery processing is completed and a CHECK CONDITION status is
reported. The sense data show the contents of the detected error.
When "1" is specified in the "SelfTest (self test)" bit in this
command, the command execution results are reported by the status
byte and the sense data. Therefore, even if the RECEIVE
DIAGNOSTIC RESULTS command is executed after this
command, the self-diagnosis test execution results are not reported
as response data.
Remark:
The error recovery control flag is valid only for PER. Therefore, the only
error recovery flag combination that is actually executed in the above self-
diagnosis tests is the (PER, DTE) = (1, 0) combination.
4-176
Diagnostic test operation
– – – – – (Setting prohibited) – – – –
C141-C012