Table of Contents
Advertisement
3. Installation
CAUTION
3.1 Installing the Console Drawer (procedure for tapped guide rails)
CAUTION
3.2 Installation Procedure
1. Insert the rear spacer studs of the guide rails into the holes in the rear rack pillars. Extend
the guide rails to reach the inside of the front rack pillar. Fasten each guide rail with four
screws, one into each of the top and bottom holes of both the front and rear spacers.
(Install the left and right guide rails at the same height.)
2. Extend the guide rails to reach the inside of the front rack pillar.
Fasten each guide rail in place with two screws, one into each of the top and bottom
holes of the front spacer. (Attach the guide rails inside the front/rear rack pillar so
that the guides face inwards.)
3. Install the left and right guide rails at the same height.
Please note the safety information in [Important Notices].
Observe the specified environmental conditions when using the
Console Drawer (See [Technical Specifications] for more information).
Avoid dust, humidity and extreme temperatures. Installation may
require two or more people in some situations. Be careful not to pinch
your fingers or hands between the guide rails and the Console Drawer.
Attach the guide rails so that they face inward and are open forward,
ready to accept the Console
Attach the guide rails inside the front/rear rack pil
See the "Installing the Guide Rails" diagra
Drawer.
m.
lar.
6
Advertisement
Table of Contents
