M2488 USER'S GUIDE
2-6
ASSEMBLY INSTRUCTIONS
These paragraphs describe the assembly and installation of the M2488 tape drive and of the optional
equipment. Use the following flowchart, in the order presented, as a guide to installing the M2488.
Each flowchart block indicates the procedure to be performed and the paragraph in this manual where
the procedure is located.
2-6.1
General Installation and Assembly Instructions
Prior to assembly, ensure all SCSI cables and power cords have been disconnected. The M2488
should be placed as near as possible to the power source.
2-6.1.1
Air Flow and Service Clearances
Allow a gap of 50 mm at the rear of the drive for heat dissipation.
Allow a 620 mm servicing area to the rear, with drive extended, for rack-mounted drives.
April 1997
Installation Procedures
General Instructions 2-6.1
Install IPM 2-6.2
Connect cables and
power cord 2-6.3
Configure the drive 2-7
CG00000-011403 REV. A
INSTALLATION INSTRUCTIONS
2-5