Installation; Package Contents Check; Preparation; Installation Area - Fujitsu ETERNUS AF Series Configuration Manual

2.

Installation

This chapter describes the installation procedures for the power synchronized unit and the AC sensor unit.
Make sure to check

Package Contents Check

Check the list of package contents in
If there are missing parts, contact your sales representative.
Table 4 List of package contents (power synchronized unit)
Package contents
Power synchronized unit
RS232C cable
Rack mount kit
Safety Precautions
Read Me First
Table 5 List of package contents (AC sensor unit)
Package contents
AC sensor unit
AC sensor port connection cable
Branch connector
Rubber foot
Rack mount kit

Preparation

Installation Area

■ Placement area
Refer to the placement area of the rack to install the power synchronized unit and the AC sensor unit.
■ Installation condition
Install the power synchronized unit and the AC sensor unit in an area that meets all the conditions described in
"Instructions for installation" (page 13)
FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)
"Safety Precautions" (page 13)
Table 4 and
Quantity
One set
Quantity
One set
of "Safety
Copyright 2019 FUJITSU LIMITED
before installation.
Table 5 to confirm that there are no missing parts.
1
1m
2
For ETERNUS DX/AF connection
1
1
1
4m
1
For power synchronized unit connection
1 —
This is not used when the AC sensor unit is installed in a
4
rack.
Precautions".
32
Note
—
—
—
—
Note
—
—
P3AM-8012-14ENZ0