Default Dscp-To-Cos Map - Cisco Catalyst 2960 series Configuration Manual

Information About QoS
IP Precedence Value
7
Related Topics
Default Mapping Table Configuration, on page 568
Configuring the IP-Precedence-to-DSCP Map, on page 606
Configuring the Policed-DSCP Map, on page 607

Default DSCP-to-CoS Map

You use the DSCP-to-CoS map to generate a CoS value, which is used to select one of the four egress queues.
The following table shows the default DSCP-to-CoS map. If these values are not appropriate for your network,
you need to modify them.
Table 72: Default DSCP-to-CoS Map
DSCP Value
0–7
8–15
16–23
24–31
32–39
40–47
48–55
56–63
Related Topics
Default Mapping Table Configuration, on page 568
Configuring the DSCP-to-CoS Map, on page 608
Configuring the Policed-DSCP Map, on page 607
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
570
DSCP Value
56
CoS Value
0
1
2
3
4
5
6
7