Consolidated Platform Configuration Guide, Cisco Ios Release 15.2(4)E (Catalyst 2960-X Switches - Cisco Catalyst 2960 series Configuration Manual

Information about Configuring Auto-QoS
CoS-to-Egress
queue map
The switch configures ingress queues on the port according to the settings in the following table. This table
shows the generated auto-QoS configuration for the ingress queues.
Table 75: Auto-QoS Configuration for the Ingress Queues
Ingress Queue
SRR shared
Priority
The switch configures egress queues on the port according to the settings in the following table. This table
shows the generated auto-QoS configuration for the egress queues.
Table 76: Auto-QoS Configuration for the Egress Queues
Egress Queue
Priority
SRR shared
SRR shared
SRR shared
• When you enable auto-QoS by using the auto qos voip cisco-phone, the auto qos voip cisco-softphone,
or the auto qos voip trust interface configuration command, the switch automatically generates a QoS
configuration based on the traffic type and ingress packet label and applies the commands listed in
Examples: Global Auto-QoS Configuration, on page 655

Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)

648
VoIP Data VoIP Routing
Traffic Control Protocol
Traffic
Traffic
2, 3, 6, 7 (queue 2)
4, 5
(queue 1)
Queue CoS-to-Queue Map
Number
1 0, 1, 2, 3, 6, 7
2 4, 5
Egress Queue
Queue Number
1 4, 5
2 2, 3, 6, 7
3 0
4 1
STP Real-Time
BPDU Video
Traffic Traffic
0 (queue 3)
Queue Weight
(Bandwidth)
70 percent
30 percent
Queue Queue Queue (Buffer) Size for
Weight (Buffer) 10/100 Ethernet Ports
(Bandwidth) Size for
Gi g abi t - Capabl e
Ports
up to100 25 percent 15 percent
percent
10 percent 25 percent 25 percent
60 percent 25 percent 40 percent
20 percent 25 percent 20 percent
to the port.
All Other Traffic
2 (queue 3)
0, 1
(queue 4)
Queue (Buffer) Size
90 percent
10 percent