Configuring Lacp Fast Rate Timer - Cisco Catalyst 2960 series Configuration Manual

DETAILED STEPS
Command or Action
Step 1
enable
Example:
Switch> enable
Step 2
configure terminal
Example:
Switch# configure terminal
Step 3 interface port-channel channel-number
Example:
Switch(config)# interface port-channel 2
Step 4
port-channel min-links min-links-number
Example:
Switch(config-if)# port-channel min-links
3
Step 5
end
Example:
Switch(config)# end
Related Topics
Configuring LACP Port Channel Min-Links: Examples, on page 361

Configuring LACP Fast Rate Timer

You can change the LACP timer rate to modify the duration of the LACP timeout. Use the lacp rate command
to set the rate at which LACP control packets are received by an LACP-supported interface. You can change
the timeout rate from the default rate (30 seconds) to the fast rate (1 second). This command is supported only
on LACP-enabled interfaces.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters global configuration mode.
Enters interface configuration mode for a port-channel.
For channel-number, the range is 1 to 63.
Specifies the minimum number of member ports that must be
in the link-up state and bundled in the EtherChannel for the port
channel interface to transition to the link-up state.
For min-links-number , the range is 2 to 8.
Returns to privileged EXEC mode.
How to Configure EtherChannels
353