Configuring Auto-Lag On A Port Interface - Cisco Catalyst 2960 series Configuration Manual

How to Configure EtherChannels
Related Topics
Auto-LAG, on page 341
Auto-LAG Configuration Guidelines, on page 342
Configuring Auto LAG: Examples, on page 360
Configuring Auto-LAG on a Port Interface, on page 356
Configuring Persistence with Auto-LAG, on page 357

Configuring Auto-LAG on a Port Interface

SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. [no] channel-group auto
5. end
6. show etherchannel auto
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Switch> enable
Step 2 configure terminal
Example:
Switch# configure terminal
Step 3
interface interface-id
Example:
Switch(config)# interface gigabitethernet
1/0/1
Step 4 [no] channel-group auto
Example:
Switch(config-if)# channel-group auto
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
356
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration mode.
Specifies the port interface to be enabled for auto-LAG, and
enters interface configuration mode.
(Optional) Enables auto-LAG feature on individual port
interface. Use the no form of this command to disable the
auto-LAG feature on individual port interface.
By default, the auto-LAG feature is enabled on the
Note
port.