Configuring A Multicast Router Port - Cisco Catalyst 2960 series Configuration Manual

How to Configure IGMP Snooping and MVR
Command or Action
Step 6
copy running-config startup-config
Example:
Switch# copy running-config startup-config

Configuring a Multicast Router Port

Perform these steps to add a multicast router port (enable a static connection to a multicast router) on the
switch.
Static connections to multicast routers are supported only on switch ports.
Note
SUMMARY STEPS
1. enable
2. configure terminal
3. ip igmp snooping vlan vlan-id mrouter interface interface-id
4. end
5. show ip igmp snooping mrouter [vlan vlan-id]
6. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Switch> enable
Step 2
configure terminal
Example:
Switch# configure terminal
Step 3 ip igmp snooping vlan vlan-id mrouter interface
interface-id
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
132
Purpose
(Optional) Saves your entries in the configuration file.
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration mode.
Specifies the multicast router VLAN ID and the interface to the
multicast router.