Configuring A Host Statically To Join A Group - Cisco Catalyst 2960 series Configuration Manual

Command or Action
Example:
Switch(config)# ip igmp snooping vlan 5
mrouter interface gigabitethernet1/0/1
Step 4
end
Example:
Switch(config)# end
Step 5 show ip igmp snooping mrouter [vlan vlan-id]
Example:
Switch# show ip igmp snooping mrouter vlan
5
Step 6
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Related Topics
Example: Enabling a Static Connection to a Multicast Router, on page 161

Configuring a Host Statically to Join a Group

Hosts or Layer 2 ports normally join multicast groups dynamically, but you can also statically configure a
host on an interface.
Follow these steps to add a Layer 2 port as a member of a multicast group:
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
How to Configure IGMP Snooping and MVR
Purpose
• The VLAN ID range is 1 to 1001 and 1006 to 4094.
• The interface can be a physical interface or a port channel.
The port-channel range is 1 to 128.
To remove a multicast router port from the VLAN, use
Note
the no ip igmp snooping vlan vlan-id mrouter
interface interface-id global configuration command.
Returns to privileged EXEC mode.
Verifies that IGMP snooping is enabled on the VLAN interface.
(Optional) Saves your entries in the configuration file.
133