Configuring Port Priority - Cisco Catalyst 2960 series Configuration Manual

How to Configure Spanning-Tree Features
Command or Action
Step 4
end
Example:
Switch(config)# end

Configuring Port Priority

Note If your switch is a member of a switch stack, you must use the spanning-tree [vlan vlan-id] cost cost
interface configuration command instead of the spanning-tree [vlan vlan-id] port-priority priority
interface configuration command to select an interface to put in the forwarding state. Assign lower cost
values to interfaces that you want selected first and higher cost values that you want selected last.
This procedure is optional.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. spanning-tree port-priority priority
5. spanning-tree vlan vlan-id port-priority priority
6. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Switch> enable
Step 2 configure terminal
Example:
Switch# configure terminal
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
230
Purpose
Returns to privileged EXEC mode.
Purpose
Enables privileged EXEC mode. Enter your password if prompted.
Enters the global configuration mode.