How To Attach An Ipv6 Source Guard Policy To An Interface - Cisco Catalyst 2960 series Configuration Manual

How to Configure IPv6 Source Guard
Command or Action
Step 5
end
Example:
Switch(config-sisf-sourceguard)# end
Step 6 show ipv6 source-guard policy policy_name
Example:
Switch# show ipv6 source-guard policy
example_policy
What to Do Next
Apply the IPv6 Source Guard policy to an interface.
Related Topics
Information about First Hop Security in IPv6, on page 678

How to Attach an IPv6 Source Guard Policy to an Interface

SUMMARY STEPS
1. enable
2. configure terminal
3. interface Interface_type stack/module/port
4. ipv6 source-guard [attach-policy <policy_name> ]
5. show ipv6 source-guard policy policy_name
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Switch> enable
Step 2 configure terminal
Example:
Switch# configure terminal
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
706
Purpose
Exits out of IPv6 Source Guard policy configuration mode.
Shows the policy configuration and all the interfaces where the
policy is applied.
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration mode.