Examples - Cisco Catalyst 2960 series Configuration Manual

Examples

Examples
Examples: Configuring PortFast Edge on a Specified Interface
This example shows how to enable edge behavior on GigabitEthernet interface 1/0/1:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# spanning-tree portfast edge
Switch(config-if)# end
Switch#
This example shows how to verify the configuration:
Switch# show running-config interface gigabitethernet1/0/1
Building configuration...
Current configuration:
!
interface GigabitEthernet
no ip address
switchport
switchport access vlan 200
switchport mode access
spanning-tree portfast edge
end
This example shows how you can display that port GigabitEthernet 1/0/1 is currently in the edge state:
Switch# show spanning-tree vlan 200
VLAN0200
Spanning tree enabled protocol rstp
Root ID Priority 2
Address 001b.2a68.5fc0
Cost 3
Port 125 (GigabitEthernet5/9)
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 2 (priority 0 sys-id-ext 2)
Address 7010.5c9c.5200
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 0 sec
Interface Role Sts Cost Prio.Nbr Type
------------------- ---- --- --------- -------- --------------------------------
1/0/1
Gi
Examples: Configuring a PortFast Network Port on a Specified Interface
This example shows how to configure GigabitEthernet interface 1/0/1 as a network port:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# spanning-tree portfast network
Switch(config-if)# end
Switch#
This example shows how to verify the configuration:
Switch# show running-config interface gigabitethernet1/0/1
Building configuration...
Current configuration:
!
interface GigabitEthernet
no ip address
switchport
switchport access vlan 200
switchport mode access
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
320
1/0/1
Desg FWD 4 128.1 P2p Edge
1/0/1