Configuring A Portfast Network Port On A Specified Interface - Cisco Catalyst 2960 series Configuration Manual
Consolidated platform configuration guide, ios release 15.2(4)e
Hide thumbs
Also See for Catalyst 2960 series:
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages) ,
- Configuration manual (120 pages)
Table of Contents
Advertisement
Command or Action
Step 5
end
Example:
Switch(config-if)# end
Step 6
show running interface interface-id | port-channel
port_channel_number
Example:
Switch# show running interface
gigabitethernet 1/0/1| port-channel
port_channel_number
Configuring a PortFast Network Port on a Specified Interface
Ports that are connected to Layer 2 switches and bridges can be configured as network ports.
Bridge Assurance is enabled only on PortFast network ports. For more information, refer to Bridge
Note
Assurance.
To configure a port as a network port, perform this task.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id | port-channel port_channel_number
4. spanning-tree portfast network
5. end
6. show running interface interface-id | port-channel port_channel_number
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
How to Configure Optional Spanning-Tree Features
Purpose
• Use the no version of the command to disable PortFast
edge.
Exits configuration mode.
Verifies the configuration.
317
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
