How to Configure an IPv6 Router Advertisement Guard Policy
SUMMARY STEPS
1. configure terminal
2. interface Interface_type stack/module/port
3. ipv6 nd raguard [attach-policy policy_name [ vlan {vlan_ids | add vlan_ids | except vlan_ids | none |
remove vlan_ids | all} ] | vlan [ {vlan_ids | add vlan_ids | exceptvlan_ids | none | remove vlan_ids |
all} ]
4. do show running-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2
interface Interface_type stack/module/port
Example:
Switch(config)#
Step 3
ipv6 nd raguard [attach-policy policy_name [ vlan {vlan_ids |
add vlan_ids | except vlan_ids | none | remove vlan_ids | all} ]
| vlan [ {vlan_ids | add vlan_ids | exceptvlan_ids | none | remove
vlan_ids | all} ]
Example:
Switch(config-if)# ipv6 nd raguard attach-policy
example_policy
or
Switch(config-if)# ipv6 nd raguard attach-policy
example_policy vlan 222,223,224
or
Switch(config-if)# ipv6 nd raguard vlan 222, 223,224
Step 4
do show running-config
Example:
Switch#(config-if)#
Related Topics
Information about First Hop Security in IPv6, on page 678
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
698
interface gigabitethernet 1/1/4
do show running-config
Purpose
Enters the global configuration mode.
Specifies an interface type and identifier; enters the
interface configuration mode.
Attaches the Neighbor Discovery Inspection policy
to the interface or the specified VLANs on that
interface. The default policy is attached if the
attach-policy option is not used.
Confirms that the policy is attached to the specified
interface without exiting the configuration mode.