Enabling Auto-Qos Compact - Cisco Catalyst 2960 series Configuration Manual

Command or Action
Step 4
exit
Example:
Switch(config-if)# exit
Step 5 interface interface-id
Example:
Switch(config)# interface
gigabitethernet 2/0/1
Step 6 auto qos trust
Example:
Switch(config-if)# auto qos trust
Step 7
end
Example:
Switch(config-if)# end
Step 8 show auto qos interface interface-id
Example:
Switch# show auto qos interface
gigabitethernet 2/0/1

Enabling Auto-Qos Compact

To enable auto-Qos compact, enter this command:
SUMMARY STEPS
1. configure terminal
2. auto qos global compact
Purpose
To view a list of commands that are automatically generated by
Note
issuing one of the auto-QoS commands listed here, you need to be
in debug mode. Refer to the Catalyst 2960-X Switch QoS Command
Reference Guide, Cisco IOS Release 15.0(2)EX for examples of how
to run the appropriate debug command to view a list of these
commands.
Returns to global configuration mode.
Specifies the switch port identified as connected to a trusted switch or router,
and enters interface configuration mode.
Enables auto-QoS on the port, and specifies that the port is connected to a
trusted router or switch.
Returns to privileged EXEC mode.
Verifies your entries.
This command displays the auto-QoS command on the interface on which
auto-QoS was enabled. You can use the show running-config privileged
EXEC command to display the auto-QoS configuration and the user
modifications.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
How to Configure Auto-QoS
653