Configuring The Dscp-To-Cos Map - Cisco Catalyst 2950 Software Configuration Manual

Configuring Standard QoS

Configuring the DSCP-to-CoS Map

You use the DSCP-to-CoS map to map DSCP values in incoming packets to a CoS value, which is used
to select one of the four egress queues.
The switch supports these DSCP values: 0, 8, 10, 16, 18, 24, 26, 32, 34, 40, 46, 48, and 56.
Table 29-8
Table 29-8
DSCP Values
0
8, 10
16, 18
24, 26
32, 34
40, 46
48
56
If these values are not appropriate for your network, you need to modify them.
Beginning in privileged EXEC mode, follow these steps to modify the DSCP-to-CoS map:
Command
Step 1
configure terminal
Step 2
mls qos map dscp-cos dscp-list to cos
Step 3 end
Step 4
show mls qos maps dscp-cos
Step 5 copy running-config startup-config
To return to the default map, use the no mls qos map dscp-cos global configuration command.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
29-36
shows the default DSCP-to-CoS map.
Default DSCP-to-CoS Map
CoS Value
0
1
2
3
4
5
6
7
Purpose
Enter global configuration mode.
Modify the DSCP-to-CoS map.
For dscp-list, enter up to 13 DSCP values separated by spaces. Then enter
the to keyword.
For cos, enter the CoS value to which the DSCP values correspond.
The supported DSCP values are 0, 8, 10, 16, 18, 24, 26, 32, 34, 40, 46, 48,
and 56. The CoS range is 0 to 7.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 29 Configuring QoS
78-11380-12