Configuring Mvr Interfaces - Cisco Catalyst 2960 series Configuration Manual

Command or Action
startup-config

Configuring MVR Interfaces

Follow these steps to configure Layer 2 MVR interfaces:
SUMMARY STEPS
1. enable
2. configure terminal
3. mvr
4. interface interface-id
5. mvr type {source | receiver}
6. mvr vlan vlan-id group [ip-address]
7. mvr immediate
8. end
9. Use one of the following:
10. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Switch> enable
Step 2
configure terminal
Example:
Switch# configure terminal
• show mvr
• show mvr interface
• show mvr members
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
Purpose
Purpose
Enables privileged EXEC mode. Enter your password if prompted.
Enters the global configuration mode.
How to Configure IGMP Snooping and MVR
149