Configuring Classification Using Port Trust States - Cisco Catalyst 2960 series Configuration Manual

Command or Action
Example:
Switch(config-if)# mls qos vlan-based
Step 4
end
Example:
Switch(config-if)# end
Step 5 show mls qos interface interface-id
Example:
Switch# show mls qos interface
gigabitethernet 1/0/1
Step 6 copy running-config startup-config
Example:
Switch# copy running-config
startup-config

Configuring Classification Using Port Trust States

These sections describe how to classify incoming traffic by using port trust states.
Depending on your network configuration, you must perform one or more of these tasks in this module
Note
or one or more of the tasks in the Configuring a QoS
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
Purpose
Use the no mls qos vlan-based interface
Note
configuration command to disable VLAN-based
QoS on the physical port.
Returns to privileged EXEC mode.
Verifies if VLAN-based QoS is enabled on the physical
port.
(Optional) Saves your entries in the configuration file.
Policy.
How to Configure QoS
573